Just like any other phone iPhone and all its models are also a touchscreen. These phones also show up with touchscreen not working problems because of various reasons. As of today, we have reached a point where we have literally no buttons at all on mobile phones and it is just all about the screen. Therefore, it is very important for you to maintain your touchscreen as all the activities and basically the whole of your phone depending on the screen or display of your phone handle it with a soft hand. Damaging the display will directly affect the usage of your phone and also the display can cost a lot almost the price of the mobile or even near that. Though, not all problems are big enough and so some of the problems that occur related to touchscreen not working in iPhones can be solved by one’s own self without taking it to any professional and increasing the repair cost or budget of your iPhone.
- If you are knowledgeable about assembling and disassembling a mobile phone properly then you can simply do this job by your own self. You do not have to carry your mobile phone to any repair store if you are thorough with this work.
- You might need a set of tools if you are planning to solve this problem of the touchscreen by yourself. There are many boxes if you can do this by yourself as you can save up a lot of money on the repairer visit and increasing the cost of it.
- You need to remove all the screws that hold up your phone using a precision screwdriver and assemble the phone very carefully. Don’t forget to keep the screws in place otherwise, it will be a difficult task to get back and assemble the phone altogether again.
- You must also remember the sequence of dissembling the phone as it will help you while assembling the phone back together.
- When you open the phone and look at the logic port you will see The IC. Different iPhones have different types of IC.
- You can simply apply no clean flux of a good quality which will help you to clean the IC properly and thoroughly without damaging it. You must do this work very carefully and with a soft hand to prevent any further damage.
- You can use a normal low dryer to dry up the IC And remember that you must do this from a little distance as keeping the blow dryer very close to the mobile phone will damage it and can lead to other bad consequences and also melt down the solder.
- Use PCB solution of good quality and clean the logic board with a soft hand. Do this job very carefully and with an intense amount of attention to prevent any kind of damage to the logic board of your iPhone.
- Now you must start assembling the phone again with all the proper way you disassembled.
- Put back all the screws and all the parts together switch on your phone and check your touchscreen which must be starting to work properly and normally by now.
- If at all the touchscreen is still not working it is time to take your mobile phone to the service store as it might have bigger problems which cannot be solved at home and need professional help.
Conclusion
Though performing this act to open up the phone and clean it from the inside is professional work someone who has a little knowledge about it or has done it in the past can try doing it again. However, if you have never done it and have no knowledge about doing it you must take the help of any videos from the internet or the best you can do is take it to a repair service store and receive professional help or you can sell old iPhone. Do whatever you feel is the best.
