How to repair a broken washing machine? How find washing machine repair in Dubai? What should I do if the washing machine malfunctions? Let’s take a look at how to deal with common failures of washing machines?
Drum washing machine repair method
1. Excessive vibration and noise of washing machine drying
Possible reasons: During the installation process, the transportation bolts were not removed or the adjustment feet at the bottom of the fuselage were not adjusted in the packaging, and the amount of washing on the uneven fuselage was too small.
2. The machine cannot be started
Possible reasons: the cabin door is not closed tightly, the power is not plugged in, and the “reservation” program is selected.
3. Drain water while water is in the washing process
Possible reason: Some washing machines that use upper drainage method to drain water, if the position of the end of the drainpipe is too low, this situation may occur. The only way is to raise the end of the drain pipe.
4. Cannot drain water after washing
Possible reasons: the drainpipe is squeezed, the drainpipe is blocked, the function selection is wrong, and the distribution of the underwear is uneven.
Washing machine repair
1. If the faucet is turned on and the water does not stop when the power is disconnected, the water inlet valve may be defective.
There is another situation when the power is turned on and it does not start to work, the water starts to enter continuously, usually because the computer control board is short-circuited.
After the washing machine starts to work, the water volume reaches the water level line and still does not stop. It may be that the water level sensor is bad or the air duct is broken.
2. How to solve the problem of clothing entanglement
Solution: Washing clothes with a laundry bag is not very clean, or put seven or eight fist-sized plastic balls in the laundry bucket to wash them together, and it will not get tangled.
3. For automatic washing machines, the impeller suddenly didn’t rotate during washing, and only a buzzing sound was heard. Remove the belt and power on and try again, and it is found that the motor is not broken.
Solution: There are two possibilities, one is the capacitance problem, and the other one is less than 10 yuan. Second, the motor lacks phase, a set of coils is blocked, and the motor windings are burned out (the no-load motor can turn to load motor but the only hum is heard).
4. The automatic washing machine fails to spin normally when it is working to the spin process during the normal washing process but jumps to the rinse process.
But the clothes can be washed normally in two or three pieces. In short, if the clothes are too much, they can’t be dehydrated and jump to the rinsing process. Don’t know what the problem is?
Solution: Actually this is normal. The reason is that you have too many clothes, one side, and are unbalanced. Jumping to rinsing is an unbalanced adjustment.
You can try to distribute the clothes evenly manually. It should be fine. If this kind of problem occurs frequently, it indicates that there are some problems with the balance system of the washing machine.
